My GE fridge is warm on one side only. What does that mean?

Most everyday GE models cool both sides from one evaporator. On those, it points to the evaporator fan or a stuck damper (the little door that lets cold air into the fridge side), not the compressor.

The ice maker stopped. Does it need replacing?

Not always. The water inlet valve, where the water comes in, fails often enough on these that it's worth testing before anyone replaces the ice maker. It costs a lot less.

Does it matter whether mine is a Profile or a builder-grade GE?

When you're deciding repair or replace, yes. They share a logo and not much else. A Profile or Monogram is worth fixing a lot longer than a builder-grade unit the same age.

What can I do to make it last longer here?

Vacuum the condenser coils twice a year. Dust plus 110-degree air is what kills these compressors in Arizona, and cleaning the coils is the cheapest way to add years to the fridge.

GE Refrigerator Repair | Pinal & Maricopa County, AZ

What we see most on refrigerators

Most no-cool calls aren't a dead compressor. Nine times out of ten it's the start relay (the little switch that kicks the compressor on), the condenser fan motor, or coils packed solid with dust. Arizona is hard on refrigerators. At 110 to 115 degrees the compressor barely gets a rest, and a unit in the garage is working in heat it was never built for.

Try this first Before you book a call Pull it out from the wall and look at the coils on the back or underneath. If they're caked with dust, vacuum them and give it 24 hours. That alone fixes a fair number of the calls we get.

Symptoms worth calling about

Fridge side warm, freezer still cold
Runs all the time, never shuts off
Ice maker not making ice
Water dispenser not working
Frost building up on the back wall
Water under the drawers

What is different about a GE refrigerator

GE makes a huge range of refrigerators. So the first step is finding out if yours is builder-grade or a Profile or Monogram, because that changes both what we look for and whether the repair is worth doing. Across the whole range, the same three things keep failing: the evaporator fan, the defrost system and the condenser. Most of the everyday models cool both sides from a single evaporator, the cold coil behind the freezer wall. On those, a warm fridge side with a cold freezer points to an airflow problem, not the compressor. Ice makers in the French-door models are a common call all by themselves. The water inlet valve (the valve where water comes into the fridge) fails often enough that we test it before anyone replaces the ice maker. Here in Arizona, keep an eye on the condenser coils (the grille of tubes under or behind the fridge). Dust plus 110-degree air is what finishes off these compressors, more than age does.

GE refrigerator guides and tips

All guides and tips →

GE refrigerator questions

My GE fridge is warm on one side only. What does that mean?
Most everyday GE models cool both sides from one evaporator. On those, it points to the evaporator fan or a stuck damper (the little door that lets cold air into the fridge side), not the compressor.
The ice maker stopped. Does it need replacing?
Not always. The water inlet valve, where the water comes in, fails often enough on these that it's worth testing before anyone replaces the ice maker. It costs a lot less.
Does it matter whether mine is a Profile or a builder-grade GE?
When you're deciding repair or replace, yes. They share a logo and not much else. A Profile or Monogram is worth fixing a lot longer than a builder-grade unit the same age.
What can I do to make it last longer here?
Vacuum the condenser coils twice a year. Dust plus 110-degree air is what kills these compressors in Arizona, and cleaning the coils is the cheapest way to add years to the fridge.

GE refrigerator down?

Call and we'll give you a flat rate before anyone opens it up.

Call (480) 791-8858 Schedule Service

(520) 788-4004 for Pinal County · (480) 791-8858 for Maricopa County